Jackknifing is the folding of an
articulated vehicle so that it resembles the acute angle of a folding
pocket knife. If a vehicle towing a trailer skids, the trailer can push the towing vehicle from behind until it spins the vehicle around and faces backwards. This may be caused by equipment failure, improper braking, or adverse road conditions such as an icy road surface. In extreme circumstances, a driver may attempt to jackknife the vehicle deliberately to halt it following brake failure.
Trailer swing
When a trailer skids to one side, this is known as a trailer swing or trailer slew. This can occur on a slippery road surface, often where there is a
cant. This is not the same as jackknifing and is not as serious, as the trailer will move back into line as the vehicle continues forwards. The driver must be aware, however, that the trailer could slide up against parked cars or a
guard rail, or that the wheels could slide into a ditch. This situation can occur especially when the trailer is empty or lightly loaded, and weather conditions cause violent gusts of
crosswind.[citation needed]
One system with limited success was a device that mechanically limited the angle which a trailer could swing.
A much more successful system was to fit the tractor with
anti-lock brakes. Fitted originally to airplanes in the 1950s, anti-lock brakes have significantly reduced the number of heavy-vehicle accidents.
Tractors were once commonly fitted with a lever in the cab to operate the trailer brakes (a trolley brake). The vehicle could be slowed or stopped using the trailer brakes only. Theoretically, this was a guaranteed way to prevent jackknifing; however, frequent use of the trailer brakes alone caused them to overheat and
fade while the tractor brakes remained fresh. In the event of an
emergency stop, the driver, applying the foot brake, could cause the trailer to jackknife because the tractor brakes lock while the trailer brakes are ineffective due to previous overheating. Trolley brakes largely disappeared from tractor units in North America in the 1980s and 1990s
An alternative to having a trailer brake lever in the cab is to fit the trailer with an
electromagnetic brake.